Feeding label paper from a paper cassette may cause printer failure. Table If you still cannot correct a printer problem even after checking the above, please contact your Kyocera Mita dealer. Toner Counter Resetting When the toner container is replaced, reset the toner counter as follows so that an accurate toner gauge measurement is indicated on the status page. The custom paper type setting is completed. Most paper has a natural tendency to curl in one direction. The virtual mailbox can be used in PCL 6 emulation only.

Uploader: Kagasar
Date Added: 16 October 2008
File Size: 57.59 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 74565
Price: Free* [*Free Regsitration Required]

Properly set the paper into the paper cassette. Pad 2 While pushing the rear cover release lever inward, remove the duplexer rear cover. In particular, avoid using paper with a surface coating or other surface treatment.

Download Center

Do not use envelopes that have an encapsulated liquid adhesive. Open duplexer rear cover and remove the paper jam.

The following symbols are used to attract your attention in this guide. Note If the paper is considerably curled in one direction, e.

Set the dimensions of paper as described in the next section. The Ecoprint mode setting is On when the printing image becomes lighter, yet very readable. Otherwise, water from the pad will cause the charger unit to become wet gs-3820n this may affect printing. See Cleaning on page Basis Weight Basis weight is the weight of a standard quantity of paper. FormFeed Time Out The printer is printing the last page after a waiting period.

See Also  3COM 3C905BTX DRIVER

Support & Download | KYOCERA Document Solutions

This chapter explains the following topics: Close paper transfer unit Open the paper transfer unit, then close tightly. See Print Quality Problems on page Off 8 Select On using the or key.

B Connecting the Printer to the Computer Deleting a Private Job To delete a stored private job, proceed as follows: All other brand and product names are registered trademarks or trademarks of their respective companies. Loading instructions are usually given on the paper package. Ultra long life modules The drum, developer, and fuser have been designed for ultra long life.

NO the duplexer is installed, remove the two cut-out portions from the 13 Ifupper fe-3820n of the duplexer rear cover removed in step 5. Remove some of the paper from the sorter tray concerned. It also lists pin assignments, signal functions, timings, connector specifications, and voltage levels. If you attempt to set the RAM disk size beyond this restriction, the printer automatically round it down so that the size is always 9 MB less than the total printer memory.


You can change the maximum space from 0 to megabytes.

Fast mode 6 Select Fast mode, Fine mode, dpi or dpi using the or key. See Auto Continue Setting on page About formatting a new Microdrive.

Support & Download

After this message is displayed, page protect mode will be On. Resource protection preserves these PCL resources in memory so that they are intact when you change the emulation back to PCL 6.

For details of fs-380n CompactFlash cards, see your dealer. If you entered an access code for the printer driver, enter the four-digit access code and press the ENTER key. Then the printer automatically warms up, goes on-line, and continues printing.

The factory default setting is A4 or Letter. Open cassette 1 and pull out paper transfer unit then remove the paper jam.